Unihertz Atom Front Camera Replacement Tutorial

This tutorial will go through the process of replacing the Front Camera of Unihertz Atom Smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the Front Camera of your Unihertz Atom smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Front Camera of Unihertz Atom

How to Replace the Front Camera of Unihertz Atom Step by Step

	Step 01 Remove the 8 screws on the back cover.
	Step 02 Take off the back cover.
	Step 03 Remove the 2 screws on the antenna bracket.
	Step 04 Take off the antenna.
	Step 05 Disconnect the FPC interface between the battery and the motherboard, and remove the battery.
	Step 06 Remove the screw on the camera bracket.
	Step 07 Disconnect the interface between the camera bracket and the motherboard.
	Step 08 Remove the camera bracket and headphone jack.
	Step 09 Disconnect the interface between the front camera and the motherboard, and then remove the front camera.
	Step 10 Take out the new front camera (please remove the lens protective film).
	Step 11 Install the camera and ensure the interface is properly connected.
	Step 12 Install the headphone jack and camera bracket, and ensure that the interfaces are properly connected.
	Step 13 Install the screw on the camera bracket.
	Step 14 Install the battery and connect the FPC interface between the battery and the motherboard.
	Step 15 Install the antenna.
	Step 16 Tighten the 2 screws to secure the antenna.
	Step 17 Arrange the waterproof gasket and fasten the back cover.
	Step 18 Tighten the 8 screws to secure the back cover.