This tutorial will go through the process of replacing the battery of Unihertz Titan smartphone.
It is important that you read the entire guide and make sure you can complete all the steps before you start to replace battery of your Unihertz Titan smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.
How to Replace the Battery for Unihertz Titan
How to Replace the Battery for Unihertz Titan Step by Step
Step 1Remove the three screws from the right edge bezel, remove the right edge bezel (Be careful not to drop the buttons) |
|
Step 2Remove the three screws from the left edge bezel, remove the SIM card tray, and remove the left edge bezel(Be careful not to drop the buttons) |
|
Step 3Remove the six screws on the right side of the device body |
|
Step 4Remove the six screws on the left side of the device body |
|
Step 5Remove the four screws that fix the rear panel |
|
Step 6Remove the rear panel gently |
|
Step 7Remove the new battery for replacement |
|
Step 8Remove the seven screws from the antenna module |
|
Step 9Remove the antenna module gently |
|
Step 10Pry up and disconnect the two battery connectors from the motherboard |
|
Step 11Pull off the battery adhesive strips (Be careful not to rip them off).If you accidentally rip off the strips, use tweezers to gently rotate to pull out the remaining strips. |
|
Step 12Pry up the original battery gently and clean up the residual adhesive strip. |
|
Step 13Check whether the interface cable is loose after removing the battery |
|
Step 14
|
|
Step 15Reconnect the two interface cables, and check whether other interfaces are loose |
|
Step 16Install the antenna module |
|
Step 17Install the rear panel, then tighten the twelve screws on both sides of the device body |
|
Step 18Install the SIM card tray |
|
Step 19Install both the edge bezels and tighten the six screws used to fix them |
Step 1Remove the three screws from the right edge bezel, remove the right edge bezel (Be careful not to drop the buttons) |
Step 2Remove the three screws from the left edge bezel, remove the SIM card tray, and remove the left edge bezel (Be careful not to drop the buttons) |
Step 3Remove the six screws on the right side of the device body |
Step 4Remove the six screws on the left side of the device body |
Step 5Remove the four screws that fix the rear panel |
Step 6Remove the rear panel gently |
Step 7Remove the new battery for replacement |
Step 8Remove the seven screws from the antenna module |
Step 9Remove the antenna module gently |
Step 10Pry up and disconnect the two battery connectors from the motherboard |
Step 11Pull off the battery adhesive strips (Be careful not to rip them off).If you accidentally rip off the strips, use tweezers to gently rotate to pull out the remaining strips. |
Step 12Pry up the original battery gently and clean up the residual adhesive strip. |
Step 13Check whether the interface cable is loose after removing the battery |
Step 14
|
Step 15Reconnect the two interface cables, and check whether other interfaces are loose |
Step 16Install the antenna module |
Step 17Install the rear panel, then tighten the twelve screws on both sides of the device body |
Step 18Install the SIM card tray |
Step 19Install both the edge bezels and tighten the six screws used to fix them |