Unihertz Jelly 2E Touchscreen Module Replacement Tutorial

This tutorial will go through the process of replacing the Touchscreen Module of Unihertz Jelly 2E Smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the Touchscreen Module of your Unihertz Jelly 2E smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Touchscreen Module of Unihertz Jelly 2E

How to Replace the Touchscreen Module of Unihertz Jelly 2E Step by Step

	Step 01 Remove the screw located at the bottom of the phone body.
	Step 02 Use a suction cup tool to separate the screen from the phone body.
	Step 03 Remove the two screws on the protective bracket.
	Step 04 Take off the protective bracket.
	Step 05 Disconnect the two cables between the screen and the motherboard.
	Step 06 Transfer the thermal silicone adhesive from the existing screen to the motherboard.
	Step 07 Transfer the proximity sensor and earpiece from the existing screen to the new screen (Note: The contact points of the earpiece should be facing upwards).
	Step 08 Connect the two cables between the screen and the motherboard.
	Step 09 Install the protective bracket and tighten the two screws on it.
	Step 10 Install the screen, ensuring that it securely fits onto the phone body.
	Step 11 Tighten the screw located at the bottom of the phone body.