Unihertz Atom Back Camera Replacement Tutorial

This tutorial will go through the process of replacing the Back Camera of Unihertz Atom Smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace the Back Camera of your Unihertz Atom smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Back Camera of Unihertz Atom

How to Replace the Back Camera of Unihertz Atom Step by Step

	Step 01 Remove the 8 screws on the back cover.
	Step 02 Take off the back cover.
	Step 03 Remove the 2 screws on the antenna bracket.
	Step 04 Take off the antenna.
	Step 05 Disconnect the FPC interface between the battery and the motherboard, and remove the battery.
	Step 06 Disconnect the interface between the camera and the motherboard, and remove the camera.
	Step 07 Apply double-sided adhesive on both sides of the camera bracket.
	Step 08 Stick the camera onto the bracket.
	Step 09 Install the camera and ensure the interface is properly connected.
	Step 10 Remove the protective film from the new lens.
	Step 11 Install the battery and connect the FPC interface between the battery and the motherboard.
	Step 12 Install the antenna.
	Step 13 Tighten the 2 screws to secure the antenna.
	Step 14 Arrange the waterproof gasket properly and tighten the back cover.
	Step 15 Tighten the 8 screws to secure the back cover.