Unihertz Titan Battery Replacement Tutorial

This tutorial will go through the process of replacing the battery of Unihertz Titan smartphone.

It is important that you read the entire guide and make sure you can complete all the steps before you start to replace battery of your Unihertz Titan smartphone. Otherwise, finding a local trained repair specialist to conduct the repair is recommended.

How to Replace the Battery for Unihertz Titan

How to Replace the Battery for Unihertz Titan Step by Step

	Step 1 Remove the three screws from the right edge bezel, remove the right edge bezel (Be careful not to drop the buttons)
	Step 2 Remove the three screws from the left edge bezel, remove the SIM card tray, and remove the left edge bezel(Be careful not to drop the buttons)
	Step 3 Remove the six screws on the right side of the device body
	Step 4 Remove the six screws on the left side of the device body
	Step 5 Remove the four screws that fix the rear panel
	Step 6 Remove the rear panel gently
	Step 7 Remove the new battery for replacement
	Step 8 Remove the seven screws from the antenna module
	Step 9 Remove the antenna module gently
	Step 10 Pry up and disconnect the two battery connectors from the motherboard
	Step 11 Pull off the battery adhesive strips (Be careful not to rip them off). If you accidentally rip off the strips, use tweezers to gently rotate to pull out the remaining strips.
	Step 12 Pry up the original battery gently and clean up the residual adhesive strip.
	Step 13 Check whether the interface cable is loose after removing the battery
	Step 14 Place the replacement battery in the location of the red frame. Remove the protective film from the new battery adhesive strip. Press the replacement battery gently to make it more fixed
	Step 15 Reconnect the two interface cables, and check whether other interfaces are loose
	Step 16 Install the antenna module
	Step 17 Install the rear panel, then tighten the twelve screws on both sides of the device body
	Step 18 Install the SIM card tray
	Step 19 Install both the edge bezels and tighten the six screws used to fix them